Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mitered return flanges

Thread starter pepper2613
Start date Feb 22, 2009

Status: Not open for further replies.

Feb 22, 2009

pepper2613

Mechanical

Hello All,
I am new to this forum. I am having alot of dificulty creating a very simple feature with Wildfire 3.0. I am drawing a very simple sheet metal cover with return flanges. I would like the return flanges mitered at 45 degrees with a tight seam to allow for welding. Is there an easy way to do this in ProE? I am struggling with this very simple task.

Thanks,