SteveFarnsworth
Mechanical
I'm using GEOPAK 2000 Series software on a Mitutoyo CMM. In the alignment process I get Error Code 63002 after getting one or two hits of the probe...any suggestions?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Mitutoyo CMM GEOPAK 2000 Series Error Code 63002
- Thread starter SteveFarnsworth
- Start date
- Status
