I'am trying to figure out a way to model an elevator shaft that does not contribute very much to the rigidity of the hole structure as to avoid causing too much eccentricity. Since it's my first time I wondered if anyone had any tips. My structure consists of rigid concrete frames with concrete slabs supported on beams, the model is 7 storeys high. Slabs are modeled as shell-thin elements.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Modeling building with elevator and stair shaft
- Thread starter Adrdm
- Start date
Similar threads
- Question
- Locked
- Question