hydronicengr
Mechanical
I was wondering if anyone knew how to properly model a restrictor or orifice in the 1D duct flow mesh in the NX Thermal/Flow package.
I've tried doing it using a mesh with a smaller diameter acting as a restrictor, but the results do not match up with an existing result that was gathered through testing. I've also tried using the "contraction" modeling object, but still no luck.
I've tried doing it using a mesh with a smaller diameter acting as a restrictor, but the results do not match up with an existing result that was gathered through testing. I've also tried using the "contraction" modeling object, but still no luck.
