SuperStress
Aerospace
- May 5, 2003
- 94
Does anyone know the correct procedure for handling surface contact between two solids in Scenario?
I've tried creating simple models with connecting meshes using the "Surface Contact" function, and cn_mesh(1), etc. are created, but the model won't run. Model check finds no errors.
The type of model I'm talking about is a simple plate with a hole and a bolt through the hole. Pull on the bolt, constrain the plate, and analyze the interaction.
I suspect that I have a constraint problem, but am unsure how to proceed.
Any suggestions?
SuperStress
I've tried creating simple models with connecting meshes using the "Surface Contact" function, and cn_mesh(1), etc. are created, but the model won't run. Model check finds no errors.
The type of model I'm talking about is a simple plate with a hole and a bolt through the hole. Pull on the bolt, constrain the plate, and analyze the interaction.
I suspect that I have a constraint problem, but am unsure how to proceed.
Any suggestions?
SuperStress