Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Modeling two plates that are stacked

Thread starter Randy2002
Start date Feb 6, 2003

Status: Not open for further replies.

Feb 6, 2003

Randy2002

Structural

Hi,
I posted a thread in the FEM forum. It has to do with designing a Sole Plate that goes between a bridge steel plate girder and the elastomeric (steel reinforced) bearing pad. Here's a link:
thread727-44756 I would appreciate it if anyone would check out the thread and respond there.
Thanks, Randy