Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Modelling Cables in SAP2000

Thread starter Chin9ere
Start date Dec 3, 2021

Status: Not open for further replies.

Dec 3, 2021

Chin9ere

Civil/Environmental

I have a bi-convex cable beam modelled in two ways; In the first case, each cable is manually drawn after the curvature has been defined, while the second cable beam beam was modelled using the SAP2000 cable form. The same loads and target forces have been applied to both beams. After analysis, I'm getting the same forces and reactions in both beams but I'm getting really different deflections. Does anyone know why?

I have attached pictures of the cable axial force, deflection and reactions results.

https://files.engineering.com/getfile.aspx?folder=746b7291-a83c-4526-b6df-fdd3d75a6971&file=Cable_force_deflectio_reaction.png