Mold drawings-inserting dimensions

[fasteddie1]

Hi Folks,
Long time listener, first time caller. I have created a male tool from using mold design chapter 20 of sworks.
Here's the problem: When I go to make a drawing to produce the new tool, the dimensions won't insert. Hmm? anything I should be looking at to turn on/off?

Frustrating since I have to build this part soon.

Thanks!

 

[CorBlimeyLimey]

In your drawing "View Manager", make sure that all options in the Annotations section are selected.

Also check that the dimensions are not going into a "hidden" layer.

& all the best.

 

[Theophilus]

If CorBlimeyLimey's suggestion doesn't work, I'd guess the feature you're trying to create was made with the Cavity feature in an assembly. If so, dimensions will not propagate to a drawing (at least, I wouldn't expect them to do so). You can add them manually if that's the case and if you have your Annotations switched on.


Jeff Mowry

http://www.industrialdesignhaus.com

Reality is no respecter of good intentions.