Motion Analysis

[Muon1]

Hi,

I'm currently using motion analysis to workout the required torque to rotate a part, but I've run into a problem. The motion analysis settings for the units of torque are N.m, how do I change this to mN.m?
Is there also a way to get the torque values without using a graph, just the actual values?

Regards

Muon.

 

[AeroNucDef]

I've had a look but I can't seem to find how to do it, sorry. It seems just to output Newton meters, not milliNewton Meters.

Hopefully someone will help.

 

[SnTMan]

/1000?

 

[Muon1]

Sorted it.

Didn't realize that N.m could be changed to mN.m in document properties - units.