Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mounting the gears in assembly generated by the GC Toolkits

Thread starter SORJM
Start date Apr 28, 2016

Status: Not open for further replies.

Apr 28, 2016

SORJM

Computer

I have created two bevel gears using GC Toolkits, one is of 23 teeth and the other with 57 teeth, the Module is of 3 mm and Face width of 20 mm then saved them in separate file. Now I want to mount them properly in an assembly. But in gears there is no tooth point or pitch diameter surface with which I can constraint them.
So what is the way to properly mount the gears generated by the GC Toolkits?