Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Move an unparameterized feature............... 2

Status
Not open for further replies.

CAD2015

Computer
Jan 21, 2006
1,932
US
Good morning,

How could I move an unparameterized feature (the yellow hole, in this case)?
Let's say, moving 10 mm on the direction of the red arrow...…..


image_m8ofwd.png


Thank you!

CAD 2015
 
Replies continue below

Recommended for you

two options:
-on the dead solid, use remove face and click on the yellow hole. Create a new whole with your requirements
-if you have part design feature recognition workbench, run the automatic/manual hole recognition--change hole sketch to your positional requirements


regards,
LWolf
 
LWolf,
I was an NX user.
In NX one could move an unparametrized feature easily.

I thought that Catia has something similar.....


Thanks for your reply!

CAD 2015
 
Natural Shape Design

NaturalShapeDesign_qzhdr7.gif


Eric N.
indocti discant et ament meminisse periti
 
Itsmyjob,

Thanks for your reply, that's exactly what I was searching for!
How could I get this feature?

CAD 2015
 
talk to DS or your VAR

Eric N.
indocti discant et ament meminisse periti
 
i m using 3dx , you check about v5

Eric N.
indocti discant et ament meminisse periti
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top