Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

MS 5479, PS 6151a and PS 7099 1

Status
Not open for further replies.

rivtim

Automotive
Apr 7, 2006
17
CA
I am quoting a threaded stud with these specifications. Any information would be appreciated.
 
Replies continue below

Recommended for you

All three are DaimlerChrysler Engineering Standards. MS-5479 specifies the requirements for carburized high-strength serrated studs. PS-6151 specified the identification requirements for metric fasteners, and PS-7099 is a general fastener specification. MS-5479 also references a number of other standards such as DCX PF-5188 and SAE J1102. DaimlerChrysler Engineering standards can be obtained directly from DCX via Covisint.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top