Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mud Jacking Specification

Status
Not open for further replies.

eric1037

Geotechnical
Jul 12, 2004
376
Hi.

I posted this on the concrete and structural engineering forums, but haven't received a response yet. I was hoping someone here would be able to assist me.

I have a project where a homeowner had some cracking and settlement in his basement floor slab.

After coring through the slab we found voids ranging from 1/16" to 1/2". The slab is underlain by a pea stone below-slab drainage system.

We would like to grout the voids and raise the slab slightly in a couple of areas where it settled.

My fear is that if the grout is too thin it will infiltrate the voids in the pea stone and render his below-slab drainage system useless or at least reduce its capabilities.

Has anyone had experience with this type of problem? If so, how do we test the grout to ensure it is thick enough? Is there a maximum slump or a flow cone value that would be appropriate?

Thanks is advance!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor