TheReg
Mechanical
- May 20, 2003
- 14
I am looking for a company that can supply a multi-head riveter. We are using 1/8 rivets and placing them on 1-inch centers, from a minimum of 6 to a maximum of 12 rivets. We would like to have a toggle switch to select which rivet would be applied.
Needless to say, I dont know if this is feasible but looking a speeding up the mfg process, in assy. I have considered moving from 1/8 rivets to 1/8 tubular shanks, due to cost but am havinf problems finding someone who can handle this objective.
Any help would be appreciated.
Needless to say, I dont know if this is feasible but looking a speeding up the mfg process, in assy. I have considered moving from 1/8 rivets to 1/8 tubular shanks, due to cost but am havinf problems finding someone who can handle this objective.
Any help would be appreciated.
