Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Multibody boolean operations

Thread starter Petre
Start date Jul 12, 2004

Status: Not open for further replies.

Jul 12, 2004

Petre

Mechanical

Hi ,
I talk about SW2004.
Are new for me multibody boolean operations in SW.I can't get a simple way to constraint to bodies finally to make a single body in part file. Also to insert a body in part file looks a little uncomfortable. I know that SW hadn't native this features, after 2003 I think, appeared.
There are some tips?
Thank you