Multiple fixture offsets and canned cycles

[NeilMGW]

Currently canned cycles aren't outputting the change in fixture offset, where's the correct place to insert the $mom_fixture_offset_value to fix the problem.

Using NX 8.5.0.23 and Post builder 8.5.0

 

[joycejo]

Your G54, or whatever code you use should be added to the cycle parameters.

Do you have a block with the fixture offset defined?

John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT
NX6 & NX7.5

 

[NeilMGW]

Hi John,

The fixture offsets are defined by an E value, here's what I have for general motion

 

[NeilMGW]

and this is for canned cycles.

Regards,

Neil