Mystery Feature Symbol for a Chamfer

[JPennington]

Hello everyone. First time poster but I've been referred here several times via Google so it must be a rich vein of knowledge

We have several German prints with this symbol, attached, describing what we've presumed to be is a chamfer.

It is a right angle (L shape)elongated lower axiz with a -0.2 inscribed there, with an arrow pointing 120 deg out from the origin.

We've also seen this read -0.3 to -0.6 which we presume to mean the tolerance is from .03 to .06

I've tried to look in ISO 8015 and ISO 2768 to no avail.

any thoughts or places I can search? Any info or tips would be greatly appreciated!

 

[TVP]

ISO 13715 is the standard that you need. The following describes what the symbol means:

http://www.en.technisches-zeichnen.net/technical-drawing/basics-02/edge-informatinos.php

 

[MikeHalloran]

Now, if someone could just translate the English into English...

Mike Halloran
Pembroke Pines, FL, USA

 

[JPennington]

Thank you very much! Indeed, this is an incredible resource...

Thanks again for the help.

 

[MintJulep]

Here is the link:

http://www.iso.org/iso/iso_catalogue/catalogue_tc/catalogue_detail.htm?csnumber=27925