NACE Sour Service Gasket

[engpes]

Are there any special gasket requirements for sour service NACE MR0175 lines? Is a standard 316 RF spiral wound gasket accepable?

Thank you!

 

[SnTMan]

engpes I don't have a copy handy, but as I recall gaskets are not within the scope. Having said that, I believe stainless spriral wound would be acceptable. You should probably seek further confirmation however.

Regards,

Mike

The problem with sloppy work is that the supply FAR EXCEEDS the demand

 

[CuMo]

You might want to check Klinger Gasket Expert software just for reference see what it comes up with depending on your fluid:

http://www.klinger.co.uk/services/gasket-selection

I hope this is not considered as advertising.