Naming parts upon creation within assembly 1

[engmaster]

In the past, while using sw07, I would create a new component by "insert - component - new part". Then I would be prompted to name the new component. I have noticed that since updating to sw09 solidworks names the component for me. Does anyone know if there is a setting to allow naming within assembly? Thanks.

 

[Eltron]

Everything relating to in-context parts has change. Look up "Virtual Components" in the Help. It's a bit of a pain in the o-ring.

Dan

http://www.eltronresearch.com

Dan's Blog

 

[CorBlimeyLimey]

The new component can still be renamed using the normal slow-double-click selection (or F2), but it would be nice to be able to name the component when inserting ... similar to the "Name feature on creation" option.

Submit an ER.

 

[MikeHalloran]

Yeah, so what's the big green check mark for?
What is SW expecting me to do?



Mike Halloran
Pembroke Pines, FL, USA

 

[CorBlimeyLimey]

Mike ... If you mean the green tick by the cursor after using the Insert > New Component tool, it's to accept and close the new component. If the cursor is hovered over an existing part in the assy, the cursor will change to a surface icon and, if clicked, will create an active sketch in the new component.

 

[MikeHalloran]

That's exactly what I meant. Thanks.



Mike Halloran
Pembroke Pines, FL, USA