Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ndt for sa350lf2 forge material

Status
Not open for further replies.
azadfar

azadfar

Industrial
Jan 15, 2015
7
Hello all
What non-destructive test should I do on the self flange with 350-lf2 material?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Are you asking what is required by a code? If so, what code? Or, are you asking about general good industry practice?

Please provide some details of what you're working on - pressure / temperature / size / etc...
 
Upvote 0 Downvote
Dimensional, visual, liquid penetrant,.......
See SA-961

Regards
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

J
  • Question
Supplier for SA612 plate material for PQR
Replies
1
Views
93
fleischfresser
fleischfresser
rachnatbovo
  • Question
Post-forming heat treatment(PFHT) for material grade 10H (Duplex & Supper Duplex) 6
Replies
12
Views
214
XL83NL
XL83NL
ShabsRBI
Old Boiler Steam Drum and Mud Drum material
Replies
3
Views
2K
r6155
r6155
nashki
  • Question
Mix System Unit in Design and Material System Unit
Replies
4
Views
3K
nashki
nashki
FPPE
  • Locked
  • Question
Air-Cooled Inconel 625: plugsheet gaskets material 2
Replies
9
Views
173
FPPE
FPPE

Part and Inventory Search

Sponsor

Back
Top Bottom