Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

need advice on stuctual setting up a double wide

Status
Not open for further replies.

tiletek

Automotive
Jun 29, 2003
1
is it possible to set a double wide on a full basement and taking out the steel beams off the house what would the best choice be as to support the center of the house . should i use i beams or can i install a center support out of lumber with support poles need help on this without it costing me a fortune thanks
 
Replies continue below

Recommended for you

Typically trailers use double beams running with its length, supporting purlins. These beams are usually supported with concrete block at regular spacing. The blocks can be replaced with beams running perpendicular to the beams at the same spacing. If the trailer is new the manufacture can provide you with the design, if not, hire an engineer to help u with the design.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor