AaronH
Mechanical
- Jan 19, 2003
- 65
All,
About a month ago I needed a 3D model of an AT10 45 tooth pulley for 50mm wide belt. 45 tooth is not standard for most vendors. I managed to locate a vendor/website that had a lot more tooth options than most vendors and downloaded the 45 tooth pulley model. Today, I need a 42 tooth pulley and, for the life of me, I cannot locate the site I was on a month ago. Apparently I did not bookmark it and my browser history doesn't go back far enough. I have looked for 2 days for this website and can't seem to locate it. Anyone know of a vendor website that has 3D models of non-standard tooth configurations? Most vendors list 40, 44, 48, and 60.
Thanks,
Aaron
About a month ago I needed a 3D model of an AT10 45 tooth pulley for 50mm wide belt. 45 tooth is not standard for most vendors. I managed to locate a vendor/website that had a lot more tooth options than most vendors and downloaded the 45 tooth pulley model. Today, I need a 42 tooth pulley and, for the life of me, I cannot locate the site I was on a month ago. Apparently I did not bookmark it and my browser history doesn't go back far enough. I have looked for 2 days for this website and can't seem to locate it. Anyone know of a vendor website that has 3D models of non-standard tooth configurations? Most vendors list 40, 44, 48, and 60.
Thanks,
Aaron