Cochav
Electrical
- Jan 30, 2018
- 1
I have recently graduated in EE and I`m in the process of getting my first job.
I have been asked to provide an answer to this question for a job selection process.
I am not sure how to approach the question, what specifically I should be looking for. Any insights on understanding the process for achieving the design would be much appreciated. I have been told this shouldn't be a hard question, but without any previous experience, I`m in need of advice.
There is circuit plan with two cans of water. One of them has a water entrance coming from some other process. For each can, there are 3 height sensors.
A plan is needed to plan a control for the water pumps to meet the process requirements. Electrical control without a controller.
Process Requirements:
1. The water should stay in containers for the maximum amount of time.
2. There should be no gliding from the container
3. A working light should be turned on.
4. A malfunction lamp should be turned on.
5. The pumps operate according to the planned command.
The power board of the pumps should be designed
I have been asked to provide an answer to this question for a job selection process.
I am not sure how to approach the question, what specifically I should be looking for. Any insights on understanding the process for achieving the design would be much appreciated. I have been told this shouldn't be a hard question, but without any previous experience, I`m in need of advice.
There is circuit plan with two cans of water. One of them has a water entrance coming from some other process. For each can, there are 3 height sensors.
A plan is needed to plan a control for the water pumps to meet the process requirements. Electrical control without a controller.
Process Requirements:
1. The water should stay in containers for the maximum amount of time.
2. There should be no gliding from the container
3. A working light should be turned on.
4. A malfunction lamp should be turned on.
5. The pumps operate according to the planned command.
The power board of the pumps should be designed
