Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Need help on cutting condition of 1/4” thick mild steel

Status
Not open for further replies.

Thanh Tran

Industrial
Jan 7, 2021
33
Hi,
What’s cutting condition to cut 1/4” thick mild steel on Mitsubishi LVP 3015 40 CFX? Thanks.
 
Replies continue below

Recommended for you

Thanks laserkatana. Can I cut this material using nitrogen?
 
You can try using a B01 nozzle and if there is a supplied cut condition for .250" MS with N2, if not use a SS Conditions of equivalent thickness.
 
There are many ways to cut mild steel plate, some of which are suited for automation some are not. Some are suited for thinner plate, some for thicker. Some are fast, some are slow. Some are low-cost, some expensive.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor