Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Need Info: In Mold Label Adhesion Testing

Thread starter cjmann10185
Start date Aug 26, 2014

Status: Not open for further replies.

Aug 26, 2014

cjmann10185

Mechanical

Hello-
I am looking to see if anyone is able to share any information regarding their test methods for in mold label adhesion on injection molded parts. We use a standard cross hatch peel test for pad print, heat transfer, etc but the IML is a different animal since it is a [in this specific application] multi layer PET label.

Thanks in advance.

Chris