Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Negative Pressure Vessel

Status
Not open for further replies.

Feedwater

Mechanical
Joined
Apr 4, 2007
Messages
1
Location
CA
This was just dropped on my desk.

I know little about pressure vessels. I was asked to qualify a cylindrical negative pressure vessel in 5 minutes. What do I need to consider? Hoop stress I know, but how do I look at wall buckling? Or any other considerations.

-10psi, ambient temperature, thin-walled cylinder.
 
Hi,
it depends in witch step are you performing,
if you have to design pressure vessel to negative pressure, it means : external pressure , so you have internal (+) and external(-),
generaly we say designing to full vaccum it means: External pressure of 14.5 psi,
in this case you consider both pressure ( internal and external ), I don't know what is your internal pressure design pressure, your design Temperature, and dimensions of your vessel, give me all this and I show you how to determine material and calculate thiknesses .

please try to be clear what are you serching .

regards.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top