Santhosh_94
Mechanical
I would like to know if is there any option for Nesting Cad profiles(.dwg) in Autodesk Inventor within a user-defined base profile rather than a pre-defined rectangular profile for blank.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
Nesting CAD Profiles in Inventor
- Thread starter Santhosh_94
- Start date
- Status
It sounds like you are interested in remnant handling - using sheet fragments from other cut jobs. There are companies that offer that capability.
Is this the sort of thing you are looking for:
Is this the sort of thing you are looking for:
- Thread starter
- #3
Santhosh_94
Mechanical
Thank you for your reply.
Precisely that is what I am looking for. Is that possible in Inventor or any other Autodesk products?
Precisely that is what I am looking for. Is that possible in Inventor or any other Autodesk products?
discusses this, but it's in their HVAC product.
- Status
