Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Nesting CAD Profiles in Inventor

Status
Not open for further replies.

Santhosh_94

Mechanical
Dec 16, 2014
25
I would like to know if is there any option for Nesting Cad profiles(.dwg) in Autodesk Inventor within a user-defined base profile rather than a pre-defined rectangular profile for blank.
 
Replies continue below

Recommended for you

Thank you for your reply.
Precisely that is what I am looking for. Is that possible in Inventor or any other Autodesk products?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor