calConfusion
Electrical
- Nov 24, 2010
- 2
Hi
I am attempting verification of the calibration standards that I am using on an old Rohde and Schwarz ZVRE network analyser.
The plan is to measure my standards on a new system calibrated with new standards and an accurate Cal Kit that I will have access to for a day. Then using these measurements I want to adjust my Cal Kit so that calibration with my standards are more accurate.
How do I relate the measured S-parameters to the values that I need to adjust in my Cal Kit saved on the VNA like Open parasitic capacitance and Short parasitic inductance and Load impedance?
Any help appreciated.
I am attempting verification of the calibration standards that I am using on an old Rohde and Schwarz ZVRE network analyser.
The plan is to measure my standards on a new system calibrated with new standards and an accurate Cal Kit that I will have access to for a day. Then using these measurements I want to adjust my Cal Kit so that calibration with my standards are more accurate.
How do I relate the measured S-parameters to the values that I need to adjust in my Cal Kit saved on the VNA like Open parasitic capacitance and Short parasitic inductance and Load impedance?
Any help appreciated.