Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

new to robotics

Status
Not open for further replies.

davidc333

Materials
Oct 23, 2015
1
my company just got a fbb robot welder and I have been elected to program it so far my biggest problem is warped metal it is either raised or lowered at the point of welds is there a trick or some command to comp for this like I said im new to this and have very limited knowledge
 
Replies continue below

Recommended for you

ABB probably has sensors available to follow the contour. Look on YouTube.

Other than that, spend a lot of time on the phone with ABB, your boss for not getting you trained, and maybe brush up your resume as buying a complex tool without training or determining suitability for the job seems like a recipe for a failed company.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor