Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

New to the Forum: Hope yall can help. RE: Tolerances for Risers, Ductile Iron, Fire Protection

Status
Not open for further replies.
Tuskasaurus

Tuskasaurus

Industrial
Jul 17, 2012
2
Can anyone direct me to a publication that gives allowable (plumb) tolerances for (vertical) risers for ductile iron.

I would greatly appreciate any and all help as I have exhausted my capabilities of 'net research!

Thanks,

Tusk
 
Status
Not open for further replies.

Similar threads

Truds
  • Locked
  • Question
Can anyway advise what the differen
Replies
2
Views
403
Truds
Truds
MujtabaQA
  • Locked
  • Question
Who can explain about Thin-wall pipe as per ASTM standard 1
Replies
6
Views
757
EdStainless
EdStainless
qcrobert
  • Locked
  • Question
How can steel manufacturer chemical composition differ from ASTM/ASME chem comp? 2
Replies
5
Views
495
qcrobert
qcrobert
Muza33
  • Locked
  • Question
heating rate applicable for normalisation of Dish end for pressure vessel
Replies
0
Views
390
Muza33
Muza33
TenPenny
  • Locked
  • Question
Codes cannot be copyrighted if they are incorporated into law
Replies
2
Views
424
SWComposites
SWComposites

Part and Inventory Search

Sponsor

Back
Top Bottom