Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

No results displayed for large analysis

Thread starter hemishark
Start date Nov 25, 2003

Status: Not open for further replies.

Nov 25, 2003

hemishark

Mechanical

I'm having trouble getting results from a large model I'm working on. Basically, I run the analysis, it runs for a good 20 to 30 mins and no results are displayed. The model pops up in Superview with the blue shading as if the stresses were "0" but there are no results. I have had some DOF and geometry errors that pop up, but they have been resolved.

I've contacted Tech Support but no real help from them yet. Anybody encounter these issues before?