Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

No subassembly visible while importing motion load to CWD

Status
Not open for further replies.

riteshharishborikar

Mechanical
Jun 15, 2007
9
IN
Hi,

There are no subassem. visible whicle importing motion loads to designer, searching knowledge base found that it can only be imported for part and not for subassembly, try to flatten strusture of assembly due to this limitation.
How practical is this anybody given a try?

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top