Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Non-reusable clutch hubs?

Status
Not open for further replies.

geesamand

Mechanical
Jun 2, 2006
688
I was skimming over a factory service manual for a Nissan 350Z manual transmission, when I noticed that Nissan recommended replacement of any clutch hub/sleeve pair removed from the tranny. I found this rather curious, and frightening from a cost standpoint.

Is it the splined fit b/t the hub and shaft, or something else that makes a used clutch hub/sleeve set unsuitable?

Dave
 
Replies continue below

Recommended for you

Maybe they're assuming the clutch dogs must be shot if you're in there, and you might as well replace them while you have them out.

It may be entirely conjectural; the factory probably has much less experience with really used transmissions than you do.





Mike Halloran
Pembroke Pines, FL, USA
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor