Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

noob nurbs question

Thread starter helicase
Start date Mar 19, 2013

Status: Not open for further replies.

Mar 19, 2013

helicase

Automotive

Tertiary surface's ... do I make them G1, G2, or G3? They are so small, and i'm thinking sheet metal presses tolerances from spring back from the elastic deformation will cancel out any fine tuning with these surfaces, so is it safe to make them G1? Thanks for the help!!!