Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

North American equivalence to "standard NF EN 10051"

Status
Not open for further replies.
thierryhcnguyen

thierryhcnguyen

Materials
Nov 10, 2010
3
Hi
the NF EN 10051 specifies tolerances for steel product in France.
I am looking for an equivalence in North America.
Does anyone know ?

Regards
 
Status
Not open for further replies.

Similar threads

MujtabaQA
  • Locked
  • Question
Who can explain about Thin-wall pipe as per ASTM standard 1
Replies
6
Views
104
EdStainless
EdStainless
Mike Mike
  • Locked
  • Question
Am I supposed to specify mortar type M, S, N, or O? 1
Replies
9
Views
110
phamENG
phamENG
Muza33
  • Locked
  • Question
heating rate applicable for normalisation of Dish end for pressure vessel
Replies
0
Views
41
Muza33
Muza33
ranidasps
  • Locked
  • Question
standard of ERW Fitting
Replies
1
Views
19
MJCronin
MJCronin
Tmoose
  • Locked
  • Question
"Tee" section straightness and sweep completely set forth in ASTM A6
Replies
2
Views
30
phamENG
phamENG

Part and Inventory Search

Sponsor

Back
Top