Dec 12, 2016 #1 WeldFixtureDesign Mechanical Dec 12, 2016 6 What does an exclamation mark (!) indicate when it is displayed following the drawing title in NX 10?
What does an exclamation mark (!) indicate when it is displayed following the drawing title in NX 10?
Dec 12, 2016 #2 looslib Mechanical Jul 9, 2001 4,205 That goes back to UG V10 in 1994! It means you have a part or parts that are out-of-date or need to be regenerated. "Wildfires are dangerous, hard to control, and economically catastrophic." Ben Loosli Upvote 0 Downvote
That goes back to UG V10 in 1994! It means you have a part or parts that are out-of-date or need to be regenerated. "Wildfires are dangerous, hard to control, and economically catastrophic." Ben Loosli
Dec 12, 2016 Thread starter #3 WeldFixtureDesign Mechanical Dec 12, 2016 6 Thank you very much. Upvote 0 Downvote
Dec 12, 2016 #4 Toost Mechanical Jan 18, 2011 2,958 Ben, your memory is on par with Johns / Tomas Upvote 0 Downvote
Dec 13, 2016 #5 looslib Mechanical Jul 9, 2001 4,205 Started using UG2 at V3.1 in 1987. Stopped at NX1, then had a bit of NX4/NX6 in 2009/2010. Used UniAPT in 1974. "Wildfires are dangerous, hard to control, and economically catastrophic." Ben Loosli Upvote 0 Downvote
Started using UG2 at V3.1 in 1987. Stopped at NX1, then had a bit of NX4/NX6 in 2009/2010. Used UniAPT in 1974. "Wildfires are dangerous, hard to control, and economically catastrophic." Ben Loosli
