Version: NX 2312
Graphics Card: Quadro P4000
I noticed that after I updated to 2312, my edges are really jagged as seen in the screenshot below. Enabling Full Scene Antialiasing solves the edges however it causes my display to lag severely (even if the model is simple), especially when zoomed in and rotating the camera. Is there another setting that I should check or is it due to my graphics card? AA seemed to work fine on NX 2007 and my GPU drivers are up to date.
Graphics Card: Quadro P4000
I noticed that after I updated to 2312, my edges are really jagged as seen in the screenshot below. Enabling Full Scene Antialiasing solves the edges however it causes my display to lag severely (even if the model is simple), especially when zoomed in and rotating the camera. Is there another setting that I should check or is it due to my graphics card? AA seemed to work fine on NX 2007 and my GPU drivers are up to date.
