NX 7.5.5.4 Why can't I use the toolbar Feature Replay while in the NX Sheet Metal Application.

[JoeBrock]

Hello everyone,
This is a stupid question I am sure.

I am trying to use the Feature Replay Toolbar inside NX Sheet Metal. The toolbar wasn't avaliable so I tried to create a new toolbar that could be used in NX Sheet Metal. But still no luck.

My Question is; Is it possible to make it so that I can use these commands in NX Sheet Metal? Or is there an option that I missed somewhere?

Hope someone can help.

Joe
NX 7.5.5.4

 

[jerry1423]

Try using the pull-down menu
Edit -> Feature -> Playback

There is the possibilty that it could be not included in your Role
so maybe change Roles to Advanced with Full Menus to see if that does the trick

 

[JohnRBaker]

That capability, being able to run 'Feature Replay' from the 'Feature Replay' toolbar while INSIDE of NX Sheet Metal, was enabled starting with NX 8.0.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[JoeBrock]

ok, Thanks John and Jerry, I new I remembered using it before. But I am currently on 7.5 not 8 so that is what I was missing. I wasn't sure if there was an option somewhere that allowed me to use it within Sheet Metal.