NX 7.5 Flat Pattern Annotation

[munners]

Is there a way to control the annotation in Flat pattern in NX Sheet Metal? Specifically, to change the "Bend Angle" and "Bend Radius" tolerance from n.nn to n?

Thanks

Munners

 

[Arkance/PhoeNX]

File -> Utilities -> Customer Defaults, Sheet Metal -> Flat Pattern, Annotation (TAB).

The content will have !KEY=0,3.2 where the 3 is before the decimal point and 2 is after the decimal point. So to change to 0 make it 3.0

For example:
Bend Radius = <!KEY=0,3.0@UGS.radius>

It's funny, I spoke to a customer about this exact question just today didn't I munners ;-)

Anthony Galante
Technical Resource Coordinator

NX4.0.4MP10, NX5.0.0->5.0.6, NX6.0.0->NX6.0.5, NX7.0.0->NX7.0.1 & NX7.5.0.32-> NX7.5.4.4, Beta NX8.0.0.25