Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX 7.5 Journal -> Need to let user pick location of point on curve/edge with cursor

Status
Not open for further replies.
cquinker

cquinker

Bioengineer
Sep 20, 2012
16
So, I'm writing journals in NX 7.5 and ran into a snag currently. I want the journal to create some geometries, then let the user select a point on a line (and thus the U Parameter of the point on the line) by the location of his cursor. Is there anyways for me to do this?
 
Status
Not open for further replies.

Similar threads

jmarkus
  • Locked
  • Question
NX Drafting Journal - Identify Location of Spline on Drawing Sheet 1
Replies
2
Views
130
jmarkus
jmarkus
Forzindi
  • Question
Can we attach a solid body through journal in NX part ?
Replies
1
Views
2K
Bleaker
Bleaker
DiaeArrahmane
  • Locked
  • Question
NX Journal: Offset of a rough surface
Replies
2
Views
211
Toost
Toost
orlandoa11
  • Locked
  • Question
NX point coordinates as properties
Replies
0
Views
159
orlandoa11
orlandoa11
CADologist
  • Locked
  • Helpful tip
NX Journal - Assign Material to All bodies in part; Assign Description to "Description Attribut 1
Replies
0
Views
291
CADologist
CADologist

Part and Inventory Search

Sponsor

Back
Top Bottom