NX 7.5: Replace with Independent Sketch - possible to reverse?

[potrero]

NX 7.5

The new function, "Replace with Independent Sketch" enables replacement of a linked curve feature with an independent sketch. This has clear advantages for a development-release workflow, where WAVE-linked sketches would be replaced with Independent Sketches upon release.

But, is there a way to reverse the action?

Or, is the best way to reverse the action to make a new WAVE link of the sketch and Replace the now-Independent Sketch with the "new", WAVE linked Sketch?

 

[JohnRBaker]

Sounds like you've found a reasonable workflow. Go for it.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[PSI-CAD]

It's very easy to create a new linked sketch before, then replace the independent sketch by the new linked sketch. (Edit Feature replace)

Regards

Didier

http://www.psi-cad.com