[NX 7] Intersection point

[cubalibre000]

Hi,
I've a multi-body part, where I need to rotate the connector from the intersection point born from connector axis and the plane.
I'm not able to create this intersection point.

Thank you...

Using NX 8 and TC8.3

 

[jerry1423]

You may need datum planes to create an intersection point.
So place a datum plane on each face that you want an interestion of.

 

[cowski]

I've always found it odd that you can't create an intersection point between a datum axis and a datum plane. The intersection point dialog insists that one of the inputs be a curve. As a workaround, I draw a line on top of the datum axis and use that for the input.

 

[JohnRBaker]

Join the club. I've asked several times for this and the explanations given have never been very satisfying, but if you would like to, please contact GTAC and have them open an ER to this effect since this will lend additional weight to the requests already there.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.

 

[cubalibre000]

Thank you to all.
I add an ER to GTAC.

Thank you...

Using NX 8 and TC8.3