Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX 8.5 - Radius Dimension Options

Thread starter ARToolingEngineer
Start date May 13, 2021

Status: Not open for further replies.

May 13, 2021

ARToolingEngineer

Aerospace

Greetings,

I have stepped back to NX 8.5 from NX 12. When in 12, I could place a radial dimension and control whether the arrow was inside or outside the arc. I'm not having success finding this option in NX 8.5. Can someone give me a boost?

Thanks,

Brent