[NX 8] Component as Reference

[cubalibre000]

Hi,
I don't understand or maybe I need to set something else, but after customer default setting and make the assembly as reference, the ANT show again the sub-assembly weight.
Can you help me to understand how to configure a sub-assembly as reference and exclude from weight calculation without some special weight management license ?

Thank you...

Using NX 8 and TC8.3

 

[JohnRBaker]

If it's not working that way you think that it should, call GTAC and have them open an IR/PR and they'll get back to you.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.