NX 8 Datum Plane Message

[Cid1979]

I am using NX8 and when using the datum command and if you pick one of the csys planes and go to a point if gives this message, now in NX 7.5 you could go from a plane on your csys to point and there was no message and it stayed parallel to the plane that you picked on the csys, in NX 8 it doesn't. Check the attached picture.

 

[JohnRBaker]

It appears to be a problem. I'm opening a PR and will let you know what I learn.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.

 

[Cid1979]

That would be great John, I am sure we will be finding more as we just loaded it 2 days ago.

 

[JohnRBaker]

If you find other issues like this, please don't hesitate contacting GTAC yourself with these.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.

 

[Cid1979]

I normally do contact GTAC, I just found it different that a simple command like that could get screwed up from one version to another.

 

[JohnRBaker]

OK, this will be fixed in the first MR (Maintenance Release) for NX 8.0. When I load the update, I'll verify that this has been addressed and will report what I've learned.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.