NX Advanced Simulation

[midoriaaien]

Hye All,

I would like to ask a question on NX Advanced Simulation settings. I am working on a hinge separation test analysis.
From the actual test, they run the test by pulling the hinge in both linear opposite direction at 5mm/min until failure.
The problem is I do not know how to apply the 5mm/min setting in this NX Nastran structural analysis. Anybody have the ideas?

 

[PSI-CAD]

Hi,

You need to add a SPCD. find herewith a jpeg file

I hope this help


Regards
Didier Psaltopoulos

http://www.psi-cad.com