o0omirkoo0o
Industrial
- Mar 29, 2020
- 10
Hi everyone.
I often follow this forum when i need some information on NX, especially when i face some difficulty.
I was looking for this kind of answer but seems that it was not faced here.
I think it's a easy issue for most of you, but for me it's not
I'm trying to create a fillet weld between two object in assembly context.
I have a cylinder and a block and i'm trying to weld this two toghether.
The problem is that NX can't complete the operation due some face issue.
I attached an image that show the two face ( 1 and 2 ) that i want to weld.
I'm using NX 1899.
Thanks so much for your support, and sorry for my poor english
I often follow this forum when i need some information on NX, especially when i face some difficulty.
I was looking for this kind of answer but seems that it was not faced here.
I think it's a easy issue for most of you, but for me it's not
I'm trying to create a fillet weld between two object in assembly context.
I have a cylinder and a block and i'm trying to weld this two toghether.
The problem is that NX can't complete the operation due some face issue.
I attached an image that show the two face ( 1 and 2 ) that i want to weld.
I'm using NX 1899.
Thanks so much for your support, and sorry for my poor english
