NX Application Wizard Setup for VS 2019 Community

[ugiismart]

Hello All ,

Start using NX1953 and Visual Studio 2019 Community edition.

To re-compile old UGOpen C++ files , first I need to install NXOpen wizards

The way I've been doing was :
- copy .../UGOPEN/vs_files to "C:\Program Files (x86)\Microsoft Visual Studio"

This case, when I try to create a new project , I can not see the UGOpen templates in the available template list.

I've been using VS Professional or VS Enterprise by this time .. It's my first attempt to use Community edition..

I wonder if I should continue with VS 2019 Pro instead ..

Need suggestions on this ..

Thanks in advance ..

Regards ..

 

[jerry1423]

Can you show a screen shot of your template list ?

Jerry J.
UGV5-NX1884

 

[ugiismart]

Hello All ,


After some investigation , it appeared that "vcprojects" folder was not created during VS 2019 installation ..

and then I did some goggling and found that Visual Studio workload : Visual Studio Extension Development

is missing and should be loaded...

Ref. :

https://developercommunity.visualstudio.com/t/wizard-plugin-for-visual-studio-2019-1/966156