Kasey7
Mechanical
- May 1, 2003
- 125
Hola!
Is there any way to improve the resolution of the turning IPW in NX7.5?
Currently Preferences > Visualization > Faceting > xxxViews are both set to Fine.
In the Customer Defaults > Manufacturing > Simulation & Visualization > IPW (whew!) all the resolutions are set to Fine.
I even tried doubling all values in the IPW Resolutions box from their defaults to 800/1400/2000 then restarted NX, but did not see any improvement.
Honestly, it's not a big deal, but it'd be nice to see corner rads rather than "chamfers" when I'm zoomed in and checking out details.
I don't know if the graphics card makes any difference but I'm using an Nvidia Quadro 4000.
(edit)
Hmm, I might have my terms mixed up. I'm referring to the the 2D overlay of the spun silhouette that appears during Generate and Verify Tool Path.
Is there any way to improve the resolution of the turning IPW in NX7.5?
Currently Preferences > Visualization > Faceting > xxxViews are both set to Fine.
In the Customer Defaults > Manufacturing > Simulation & Visualization > IPW (whew!) all the resolutions are set to Fine.
I even tried doubling all values in the IPW Resolutions box from their defaults to 800/1400/2000 then restarted NX, but did not see any improvement.
Honestly, it's not a big deal, but it'd be nice to see corner rads rather than "chamfers" when I'm zoomed in and checking out details.
I don't know if the graphics card makes any difference but I'm using an Nvidia Quadro 4000.
(edit)
Hmm, I might have my terms mixed up. I'm referring to the the 2D overlay of the spun silhouette that appears during Generate and Verify Tool Path.